
Computer Diagnostics
Full-system module scans, live data analysis, coding and adaptations for European electronics.
Dealer-level scan tools, honest answers, and deep diagnostic expertise for European imports in Englewood, CO.
Modern European cars run on dozens of networked control modules. A flashing warning light is rarely the real story — it's a code pointing at a system that needs to be tested, not guessed at.
We connect manufacturer-level scan tools to your vehicle, read every module on the bus, and walk you through exactly what's failing and what it will cost to fix. No upsells, no guesswork.
A small, owner-operated shop focused on European imports — with the equipment and the patience that complex cars need.
Specialized work that most general shops can't do without sending your car to the dealer.

Full-system module scans, live data analysis, coding and adaptations for European electronics.

AT, CVT and DSG/DCT diagnostics, fluid service, mechatronic repairs and rebuilds to factory spec.

Timing chains and belts, oil consumption diagnosis, turbo systems, gasoline and diesel overhauls.

Air-ride troubleshooting, control arms, bushings, performance pad and rotor service.

Pressurized ATF and transfer-case exchanges, coolant and brake fluid bleeds, factory-scheduled maintenance.

Full module scan plus mechanical and structural inspection with a written report before you buy.
Warning lights for ABS, traction control, airbags and power steering almost always trace back to a specific sensor, module, or wiring fault. We test before we replace.
A check-engine light is a starting point, not a diagnosis. We pull freeze-frame data, monitor live sensors, and verify the failure before quoting parts.
Misfires, oil consumption, rough idle, loss of power, turbo problems, EVAP and emissions codes — we work through them systematically on gasoline and diesel European engines.
Driving with an unresolved misfire or low-oil-pressure warning can destroy a catalytic converter or seize an engine in minutes. Get it checked.
Automatic gearboxes (AT, CVT, DSG/DCT) are precision hydraulic-electronic systems. Most failures show up as electronic fault codes long before mechanical damage starts.
We read transmission-specific modules, monitor live clutch and solenoid data, and check fluid condition under load. That tells us whether you need a fluid service, a mechatronic repair, or a full rebuild.
Don't keep driving a car that's slipping, shuddering on light throttle, or refusing to shift. Continued use turns a $400 service into a $5,000 rebuild.
If you notice any of the following, schedule a diagnostic visit before the next long drive.
A transmission that has gone into limp mode is protecting itself. Have it scanned the same day — don't reset the light and keep driving.
Most European transmission failures are preventable with the right service interval and the correct fluid.
Buying a used European car? Bring it to us first. A two-hour inspection can save you thousands.
Read every control module on the car and check stored, pending and historical fault codes.
Engine, transmission, suspension, brakes, steering, exhaust and drivetrain checked on a lift.
Condition and level of every fluid, plus inspection for leaks at every gasket and seal.
Photo-documented summary with severity ratings and realistic repair estimates you can use in negotiation.
On most European engines, a failed timing component means a destroyed engine. Replace on schedule — not when it breaks.
Following the correct service schedule with the right fluids is the cheapest insurance you can buy on a European car.
Decades of combined experience with European imports — and the dealer-level tools to back it up.
Beyond diagnostics and transmissions, we cover the day-to-day work a European car needs.
Call or email — we'll confirm a same-week appointment in most cases.
Speak directly with our master technicians. Honest diagnostics, dealer-level tools, and OEM-spec repairs — no upsells.